Water Heater Repair in Richmond Hill and Surrounding Areas

We at Mr. Rooter Plumbing of Savannah are devoted to solving any plumbing-related problem you cannot solve yourself. Your water heater may have occasional hiccups, but that doesn’t always mean it’s broken or about to fall apart. Sometimes, they just need a little attention and minor maintenance. Here are some common water heater issues that may arise at some point, as well as some tips on how to solve these problems:

• Water Temperature: There is something amiss if water heaters aren’t properly heating your water as intended. If the water is icy cold, this is usually a sign of a loss of power or a faulty heating element. You can start narrowing down the problem by replacing blown fuses and checking that the power indicators are on and lit up. If the water is warm but not hot, there could be a crossed connection or a faulty thermostat.

You can rule out a crossed connection by shutting off your water and turning on a hot water faucet. If the water is still flowing, then your connection is crossed. We recommend calling Mr. Rooter Plumbing of Savannah. We can send a professional to check your thermostat and make sure you have a water heater that’s properly sized to handle your entire property.

• Water Leaks: Leaks are almost always a bad sign, and they need to be addressed as quickly as possible before they evolve into a much bigger problem. Leaks can be caused by many different things, such as:
  • Stuck valves
  • Loose gaskets
  • Bad water pressure
  • Faulty relief valve
  • Overheating
  • Loose plumbing connections

Tighten any bolts you can to see if this fixes the leak. If the unit continues to leak, it could be a problem with the gaskets or valves. At that point, it is recommended that you reach out to a professional. Mr. Rooter Plumbing will send someone to evaluate the problem causing your leak.

• Slow Heating: Sometimes, your water might take a long time to heat up. This can be a sign that something is wrong. Sediment buildup in the tank can hold back the heating element due to increased insulation. It could also be caused by a faulty heating element, particularly if you have an electric water heater. Adjust your thermostat to a higher setting or flush the tank to eliminate unwanted sediment. If that doesn’t work, consult a professional.